How to Replace the Filter in PETLIBRO PLWF106
The PETLIBRO PLWF106 Dockstream 2 Smart Fountain is the plug-in, corded Dockstream 2 model. It uses a flat Dockstream replacement filter and a foam pre-filter installed in the water pump cover.
Its stainless steel water tray and filter tray are integrated and should not be separated.
Open full-size image.
Open full-size image.
Quick Answer
- Unplug the fountain.
- Remove the tank from the base and discard the used water.
- Soak the new flat filter in tap water for five minutes, then rinse it thoroughly.
- Remove the spout and filter cover, then remove the used flat filter.
- Replace the foam pre-filter in the water pump cover.
- Install the soaked flat filter and close the filter cover.
- Fill the tank, install the integrated tray, snap the lid into place, route the cord through a bottom cable slot, and restart.
Items Needed
- New flat Dockstream replacement filter
- New foam pre-filter
- Tap water for soaking and rinsing
- Fresh water for refilling
- Original PLWF106 power adapter
Before You Start
Unplug the fountain before changing the filter.
Remove the tank from the base and discard the used water.
Rinse tank parts with water below 50 C. Do not wash or submerge the base.
Open full-size image.
Replacement Instructions
Step 1: Remove the Old Flat Filter
Lift off the spout and filter cover. Remove the used flat filter from the integrated filter tray.
Step 2: Replace the Foam Pre-Filter
Remove the old foam filter from the water pump cover. Insert the new foam filter into the same opening, then place the water pump cover inside the tank.
Open full-size image.
Step 3: Install the Main Filter
Place the soaked and rinsed flat filter into the filter tray. Install the filter lid so the filter sits flat and the parts align correctly.
Open full-size image.
Step 4: Fill, Close, and Route the Cord
Fill the tank with fresh water, install the integrated stainless steel water tray and filter tray, snap the lid into place, and route the power cable through one of the cable slots on the bottom of the fountain.
Open full-size image.
Step 5: Restart and Check
Place the tank back on the base, connect the original power adapter, switch the fountain on, and check that water flows normally.
Maintenance Tips
- Clean the water tank and internal parts every week.
- Replace the filter every week unless the product packaging for your replacement filter kit gives a different interval.
- If flow is weak or irregular, confirm that the foam filter, flat filter, cover, and tray are seated correctly.
Confirmed Replacement Timing
The available PLWF106 PDF recommends cleaning the water tank and internal parts every week and replacing the filter every week.
Important Notes
FAQ
Can I skip soaking the new filter?
No. The matching PDF instructions say to soak the new main filter for five minutes before installation and rinse it before use.
Should I soak the filter inside the fountain tank?
No. Use a separate clean bowl or container so loose filter dust is not introduced into the fountain tank.
What should I check if water flow is weak after replacement?
Check that the filter, cover or lid, water pipe, tray, pump area, and tank are seated correctly for your model.
Is PLWF106 the cordless Dockstream 2 model?
No. The PLWF106 PDF identifies it as the plug-in, corded model.
Final Summary
For the PETLIBRO PLWF106, follow the matching PDF for the exact filter type, preparation time, part order, and model-specific checks. Use only the diagrams and steps for this model when replacing filters.
PDF Guide and Products
Open the printable guide or view the matching fountain and replacement filters on Amazon.