How to Replace the Filter in PETLIBRO PLWF006
The PETLIBRO PLWF006 3L Stainless Steel Pet Water Fountain uses an activated carbon filter in the filter housing and a pump sponge around the pump.
This model does not use the Dockstream flat filter used by PLWF005, PLWF105, PLWF115, PLWF106, or PLWF116.
Open full-size image.
Quick Answer
- Turn off and unplug the fountain.
- Lift the top cover by its handle.
- Remove the used filter from the filter housing.
- Soak the new activated carbon filter in a clean bowl for five minutes, then rinse it.
- Confirm the pump holder, pump sponge, and pump are securely positioned.
- Place the prepared carbon filter in the housing and press the housing closed.
- Fill between the MIN and MAX marks, replace the top cover, reconnect power, and confirm normal water flow.
Items Needed
- Compatible activated carbon filter
- Replacement pump sponge
- Clean bowl
- Clean water for soaking and rinsing
- Water for refilling between MIN and MAX
Before You Start
Disconnect the power adapter before lifting the top cover.
Remove the used activated carbon filter from the filter housing.
Use a clean bowl to soak the new filter; do not soak it inside the fountain tank.
Open full-size image.
Replacement Instructions
Step 1: Open the Fountain
Lift the top cover by the handle and set it aside on a clean surface.
Step 2: Check the Pump and Sponge
Install the pump holder first, place the pump into the sponge, and press the pump firmly so it is held securely.
Open full-size image.
Step 3: Install the Carbon Filter
Place the soaked activated carbon filter into the filter housing. Press the housing closed at the marked latch area.
Open full-size image.
Step 4: Refill and Restart
Add water between the MIN and MAX marks. Put the cover back on, reconnect the power adapter, and confirm that water flows normally.
Open full-size image.
Maintenance Tips
- Replace the carbon filter and pump sponge at least once every two weeks.
- Clean the pump and fountain at least once every two weeks.
- Keep the water level above the pump so it does not run without enough water.
Open full-size image.
Confirmed Replacement Timing
The PLWF006 PDF confirms a replacement interval of at least once every two weeks for both the activated carbon filter and the pump sponge.
Important Notes
FAQ
Can I skip soaking the new filter?
No. The matching PDF instructions say to soak the new main filter for five minutes before installation and rinse it before use.
Should I soak the filter inside the fountain tank?
No. Use a separate clean bowl or container so loose filter dust is not introduced into the fountain tank.
What should I check if water flow is weak after replacement?
Check that the filter, cover or lid, water pipe, tray, pump area, and tank are seated correctly for your model.
Can I use Dockstream flat filters in the PLWF006?
No. The PLWF006 PDF says this model uses an activated carbon filter and pump sponge, and it identifies the PLWF003/PLWF006 replacement set.
Final Summary
For the PETLIBRO PLWF006, follow the matching PDF for the exact filter type, preparation time, part order, and model-specific checks. Use only the diagrams and steps for this model when replacing filters.
PDF Guide and Products
Open the printable guide or view the matching fountain and replacement filters on Amazon.